First, roll all of the lemons, one at a time. Press down with your hand and roll until you feel the lemon become sort of “squishy.” The purpose of this is to release the juice inside the lemon. This step is very important; it helps you get the maximum response from your lemons.

Push and then twist a zinc-plated screw into one of the lemons about 1/3 of the way from one end. With the knife, carefully cut a 1 cm (3/4 in) slit into the lemon about 1/3 of the way from the other end.

CAUTION: It might be better for an adult to handle the knife. In all cases, please work with the knife SLOWLY and CAREFULLY.

Insert a copper coin into the slit so that about half of the coin is inside the lemon.

Note: Make sure you use a shiny new coin for this. If it is old and dull, polish it with steel wool.

Believe it or not, you can now get electricity from the lemon!! It behaves like an electric cell, with the coin as the positive (+) terminal and the screw as the negative (-) terminal. Unfortunately, it is a very weak cell. But if you have a couple more, you can join them to make a lemon battery.
Add coins and screws to the other two lemons the same way you did with the first. Then, with the wires and clips, join the three lemon cells together, so that the screw of the first lemon is connected to the coin of the second lemon, and so on. Add wires and clips to the first coin and the last screw also.

Finally, label the clip from the first coin with a “+” and the clip from the last screw with a “- “. Like a real battery, your lemon battery has a positive (+) terminal and a negative (-) terminal.

When connected like this in what is called a series connection, the lemons work together to create about the same voltage, or electrical force, as a couple of small flashlight batteries, somewhere between 2.5 and 3 volts. But this lemon battery does not create enough electrical current to light a flashlight bulb.

How can we tell if we really have created a battery? One way is to connect it to an electronic device that needs no more than about 2.5 to 3 volts but that does not require much electrical current. One such device called a light emitting diode, or LED for short. A low voltage and small current can cause an LED to light up.

The specifications on our LED package are: 5mm Red LED, 1.8 volt, 20mA. This means the diameter of the LED is 5 mm, and that it requires 1.8 volts and 20 milliamps of current to light up. Actually, the LED will light up dimly with less than 20 milliamps. Our lemon battery has enough volts but not nearly enough milliamps. So we will have to find a way to see its dim light. We tried enclosing it in a film canister to shield it from outside light.

With the nail, CAREFULLY punch two holes in the sides of the film canister, about halfway down. You might want to get an adult to do this for you.

Next, mark one hole with a “+” label and the other with a “-“ label.

Bend the wires of the LED into smooth outward curves. Then observe the LED closely. It is mostly round. However, if you tilt it in a certain way, you will be able to see a flat surface near one of the wires. The wire nearest this flat surface is the negative terminal. In the photograph, the wire on the left is the negative terminal of the LED. Can you see the small flat surface by the leftmost wire?

Line up the negative terminal wire of the LED with the “-“ labeled hole in the film canister. Insert the LED into the canister. Thread the negative terminal wire of the LED through the “-“ labeled hole, and the other (positive terminal) wire through the “+” labeled hole.

Pull the wires through the holes and secure them in place with the labels. Add labels to the top of the canister as well. Make sure that the LED is facing up.

Let’s get everything prepared for the big moment. Line up the “+” side of the LED canister with the “+” clip of your lemon battery. Bring the “-“ clip of your lemon battery close to the “-“ side of the canister.

Now we are ready! Connect the positive terminal of the LED to the positive terminal of your lemon battery. Connect the negative terminal of the LED to the negative terminal of your battery. The LED lights up!!

The LED is very dim, due to the small electrical current from your battery. The dark canister helps you to see this dim light. The end of the LED acts like a magnifying glass. When you look directly into the end of the LED, you can see the light easily.

This proves that you really have made a lemon battery that works!! Congratulations!!

Troubleshooting

If you can’t see the LED light up try these fixes:

1. You may have the polarity of the LED reversed, that is, the + and - switched. Reverse the LED and see if it lights up.
2. The LED may be very dim. Dry it in a darker room and let you eyes adjust to the dimmer light before testing.
3. Make sure all of the connections are secure: wires clipped to the coins and screws and coins and screws firmly in the lemons.

More Things To Try

• Over time, the voltage in your lemon battery will go down. See how long your lemon battery will last. After a while, you might notice a darkening of a lemon near the screw. If you remove the screw and insert it (or a new zinc-plated screw) at another place in the lemon, you can partially restore the strength of your battery. You can also “juice up” your battery a little bit by moving the pennies in and out of their slots from time to time.

• Try more than three lemons connected together. Is the LED light brighter? Does the lemon battery last longer?
• Try larger pieces of copper and zinc.
• Try using an incandescent bulb - the kind used in a flashlight. Can you make a fruit battery strong enough to light it?
• Try other fruits and vegetables, such as potatoes and tomatoes. What about grapefruit and oranges? Can you think of a way to try bottled lemon juice?

• Obtain an electronic instrument called a multimeter. This device allows you to measure voltage directly. What is the voltage of your lemon battery? What is the voltage from a single lemon cell?

• Now think BIG with the idea of the lemon battery: Build this supersized cell

		Digging Deeper
		Find out more about
	how the lemon battery works.

…more Science Lab projects about…
Air & Space
Earth Science
Electricity & Magnetism
Properties of Liquids

…try some interactive experiments in our…
Virtual Lab

…or test your skills at our…
Math Puzzle of the Month
Engineering Challenge